GRAINGER 480Z93 Mobile Cart Security Paneling, 35.9 x 20.1 x 24.5 Inch Size, Tan, Steel

It is an interlocking steel panelling system that secures the utility cart's contents against theft and features 16-gauge steel panels that can be installed in 15 minutes or less.

Features:

• The design allows installation on a new rolling tool cart or retrofitting an existing toolbox cart.
• The recessed padlock design allows a wide range of padlocks while keeping the lock from snagging on doorways, materials or clothing.
• Connect power to the interior of the mobile tool cart via a grommeted electrical pass-through, which protects the cord.
• The tan, powder-coat finish provides resistance against chipping and scratching.

Frequently Asked Questions:

Q. How to install a steel panel?

A.

• Allow the bottom of the back panel to rest on the cart's ledge (on the long sides). Attach the corner clamp with two carriage bolts and two 1/4-20 whiz nuts. Repeat the procedure on the opposite side.
• Allow the bottom of the end panel on the short side of the cart to rest on the cart's ledge. Using two carriage bolts and two 1/4-20 whiz nuts, attach to the previously installed corner clamp. Repeat the same on the opposite side.
• Using three 1/4-20 carriage bolts and three 1/4 whiz nuts, install the remaining two corner clamps on each of the front corners.
• Use two 1/4-20 carriage bolts and two 1/4 whiz nuts to secure the door latch.
• Attach the left side front panel to one of the cart's fronts with three 1/4-20 carriage bolts and three 1/4 whiz nuts. Repeat this for the right front panel.
• Use five #10-24 x 1/2 inch screws and five #10-24 whiz nuts to attach the door to the right side front panel. Tighten using a 5/16 inch socket and 3/8 inch wrench.
• Adjust the front side panels and the door latch up & down until they align and a padlock can be installed.
• Check the padlock's functionality and make necessary adjustments. Once adjusted, tighten the door latch bolts with a 7/16 inch wrench and all fasteners with an electric driver & a 7/16 inch socket.

Q. How do you install the grommet?

A. Choose which end you want the grommet attached to, then tap the grommet into the knockout (provided) with a hammer.

Q. Which units can I install this unit on?

A. This unit fits utility carts seamlessly.