HT800 Series Flat Head Push-Pull Units(6 Products)
EATON

• When these buttons are pushed or pulled, they activate a switch that closes / opens an electrical circuit.
• These maintained push-pull pushbuttons remain in the activated / deactivated position until they are pushed / pulled again.

• Eaton HT800 Series flat head push-pull units have NEMA-rated watertight / oil-tight bodies to prevent dirt and moisture ingress.
• Their flat mushroom head plastic actuator provide an easy-to-press surface.
• These pushbuttons have black anodised buses to establish secure connections.

Q. How do I troubleshoot a pushbutton?

A.

• Make sure that the pushbutton is properly connected to the circuit.
• Ensure that the switch inside the pushbutton is not stuck in the open or closed position.
• Make sure that moisture or dirt is not affecting the operation.

Q. Can these pushbuttons be used with a resistor?

A. Yes, pushbuttons can be used with a resistor to provide additional protection.

Q. How do I replace a pushbutton?

A.

• To replace a pushbutton, first disconnect the power to the device or circuit.
• Remove the old pushbutton by carefully disconnecting wires or cables.
• Once the old pushbutton is removed, install the new pushbutton by attaching the wires or cables to the appropriate terminals and securing the pushbutton in place.
• Finally, restore power to the device or circuit and test the new pushbutton to make sure it is functioning properly.