IMPERIAL 275-FS Flaring (45 Degrees) and Swaging Tool, Screw-Type Feed

Imperial 275-FS flaring and swaging tool is used for connecting copper tubing and gas pipes. This tool is ideal for joining pipes of different sizes in HVAC systems.

Working Mechanism:

• Take an Imperial tube cutter and cut the tubing into squares.
• Ensure all burrs and turned-down edges are removed.
• Insert the tubing into a die of the corresponding size and make sure it is slightly above the top of the die.
• Tighten the wing nut nearest to the tube.
• Place the flaring cone in the centre over the tubing.
• Tighten the flaring tool to lower the press into the tubing until it forms a flare.
• Loosen the flaring tool and remove the flared tubing.
• For swaging, secure the tube in a vice or hold it by hand with a firm grip.
• Match the diameter of the tube to the appropriately sized punch and put the narrow end inside the tube.
• Ensure perfectly straight alignment.
• With a hammer, strike the end of the punch until the tube meets the stop.

Features:

• Imperial 275-FS flaring and swaging tool has a sliding T handle to tighten the tube with the bar to prevent slipping.
• This tool consists of swivel-type swaging adapters and a flaring cone featuring hardened steel construction with a chrome finish for easy operation.
• It features a self-centring slip-on yoke design for easy flaring in compact spaces.
• This product comes in a high-quality tool case for safe storage and easy portability.
• It has two bars to deliver flares in nine different sizes.

Compatible Accessories:

• Imperial S38600 Replacement Flaring Cones: These flaring cones can be installed in place of the standard cone for higher efficiency.

Frequently Asked Questions:

Q. What is the overall length of this flaring tool?

A.

• 7 inches

Q. What is the type of flare produced?

A. This flaring tool can produce single lap flares at 45 degrees.

Q. What is a flaring tool?

A. Flaring tool uses pressure to make mechanical joints to connect pipes with a flare connection.

Q. What is a swaging tool?

A. Swaging tool uses pressure to stretch one end of a tube so that it can fit over another tube of the same diameter.